BLEC CP Series, Инструкция и каталог запасных частей

Страница: 17 / 38

17
SECTION 7 - PREPARING FOR USE
BLEC CULTI-PACK SEEDER
MODELS - CP36/CP42
TYPE OF SEEDING SYSTEM
The Cultipack seed hopper is equipped with an accurate seeding mechanism, which
Consists of a stainless steel bottom with two sliding sections which have specially
Shaped apertures (holes) inserted in each part. To vary the amount of seed to be
Spread, you must slide the bottom section to either increase or decrease the hole
Size. This is achieved by twisting lever A (see Photo 5a) until the tab touches the
Side of the numbered cam gauge (see photo 7)
New 2006 onwards models are fitted with a shut off plate, which is operated by twisting
Lever B (see photo 5a) until the plate drops down, therefore allowing the grass seed to fall
Out. By lift lever B up, and then twisting to lock up plate, this stops the seed from falling out.
The numbers on the cam gauge DO NOT represent a specific amount of seed, it is only a
Scale to work from.
A blanking tray is provided which slides under the hopper chute, allowing seed to be collected
Ready for calibration (see photo 8)
For calibration procedures please see page 7.