Blaze Outdoor Products Instructional Book
Page | 21
Version 1.4
5.
Push in and turn the control knob to HIGH.
6.
If the burner does not light after five seconds, turn the control knobs to the OFF position.
7.
Wait five minutes until the gas clears before attempting to light it again.
8.
If the burner does not light after several attempts, immediately close all gas valves and consult an
authorized service technician.
Flame Adjustment
Become familiar with the safety instructions at the front of this manual. Do not smoke while lighting the
appliance or checking the gas supply connections.
Make sure that all gas connections are securely tightened and have been leak-tested with a soapy
water solution - never with a flame!
With the cooking grids and flame tamers removed, light the main burners and run them on the high
setting.
Inspect burners for proper flame appearance. The ideal flame appearance is one that is mostly blue
and not lifting off of the burner surface. There is an air shutter found at the end of the burner (close to
the valve) which can be either opened or closed to make adjustments to the flame's appearance. To
adjust, remove the burner from the appliance and loosen the phillips head screw holding the air shutter
to the burner. If the flame is yellow, open the air shutter to make the flame bluer. If the flame is lifting off
“FLASHBACK”
may occur in or around the burner tubes. Flashback exhibits a characteristic
“whooshing” sound. If this should occur, immediately turn off your burners, then remove and clean them
with soap, water and a brush until all foreign objects are removed.
