PI-1010A
Page 18
DATE PRINTED: 4/7/11
Version 1.05
Assembly Instructions for Princess PI1010A Insert
There may be local building and fire codes which could affect your installation so be sure to check with your local
building inspector, fire inspector or other local authorities having jurisdiction in your area before you begin installation.
This insert is certified for installation into a masonry fireplace or factory built fireplace listed to UL 127 or ULC S620 only.
They must also be carefully inspected and in good condition.
Blaze King recommends that you use a qualified Blaze King installer to assemble and properly install your
PI1010 insert. Technicians are certified by the HPBA in the USA and by WETT in Canada.
We recommend that that our wood hearth products be installed and serviced by professionals who are certified In the
U.S. by the National Fireplace Institute* (NFI) as NFI Wood Specialists.
Provide protection for the hearth to prevent damage while sliding the heavy insert in and out of the fireplace opening.
1) Carefully remove and inspect the insert parts in the shipping packages. The parts should include the 2 shroud side
panels, 1 shroud top panel, 1 shroud outer trim package, 1 shroud convection deck, 2 #6-32 brass screws .
2) Place the fireplace insert on the work area. Note: This unit is shipped without any shroud parts in place. Attach the
two-shroud side panels to the unit by loosening the screws on the covers on either side of the unit and sliding the
shroud sides between the covers and the unit. Retighten the screws ( see Fig. 2 ).
Figure 1
Assembly - General
Figure 3
Figure 2
