Blaupunkt MEMPHIS MP66, Инструкции по эксплуатации и монтажу

Страница: 45 / 384

EN
GLISH
Changing basic settings in the settings menu
45
in the installation instructions.
You can adjust this volume in-
crease from 0 (no increase) to 5
(maximum increase).
Press the softkey
9
(next to
"Auto Sound").
The "Auto Sound" menu appears.
Note:
If no increase is set, the display
shows "AUTO SND OFF".
On the rocker switch
3
, press
or to raise the volume in-
crease.
On the rocker switch
3
, press
or to lower the volume in-
crease.
Setting the bass increase ( X-Bass)
X-bass is a bass increase at low
volume. This bass increase can be
set in increments from 0 (no in-
crease) to 6 (maximum increase)
for the following frequencies:
32 Hz, 40 Hz, 50 Hz, 63 Hz, or
80 Hz.
Press the softkey
;
(next to
"X-Bass").
The individual frequencies are
displayed as bars and the bass
increase as bar segment.
On the rocker switch
3
, press
or to select the desired fre-
quency.
On the rocker switch
3
, press
or to set the desired bass
increase.
➔
➔
➔
➔
➔
➔
Switching off the equalizer
Press the softkey
:
in the
"Digital Equalizer" menu (next
to "Off").
Confi guring the preamplifi er out-
put for the subwoofer ( Subout)
If you want to use an additional
subwoofer, it can be adjusted to
the other loudspeakers.
You can adjust the level of the
Subout preamplifi er output in 13
increments from –6 dB (maxi mum
decrease) to +6 dB (maximum in-
crease) for one of the following
cut-off frequencies: 80 Hz, 120
Hz, or 160 Hz.
Press the softkey
:
in the
"Audio Settings" menu (next
to "Subout").
The "Subout" menu appears.
On the rocker switch
3
, press
or to select the desired cut-
off frequency.
On the rocker switch
3
, press
or to set the desired level
of the preamplifi er output.
➔
➔
➔
➔
01_BA_Memphis_US_gb.indd Menü45 01_BA_Memphis_US_gb.indd Menü45 05.09.2007 9:58:12 Uhr 05.09.2007 9:58:12 Uhr