7
8
ATTACHING THE GRASS COLLECTION BOX (Fig.4)
1. Ensure that the grass collection box has been assembled correctly.
2. Lift the rear deflector (8) on the mower deck.
3. Pass the collection box under the handlebar, align the attachment
hooks and place the collection box into position.
4. Lower the rear deflector, so that it now rests on the grass collector box.
OPERATION
ADJUSTING THE CUTTING HEIGHT
NOTE: Stop, release switch lever and wait until the motor stops before
adjusting height. The blades continue to rotate for a few seconds after the
machine is switched off, a rotating blade can cause injury.
For the first cut of the season, a high cutting adjustment should be
selected.
The cutting height can be selected among 20mm, 40mm, or 60mm by
adjusting the front and rear wheels.
Front wheel adjustment (Fig.5)
Pull the front wheel axle on either side of the mower deck in turn and
relocate it in the required position.
Rear wheel adjustment (Fig.6)
Pull the rear wheel axle along the slot and lift the wheel, then relocate it in
the required position.
OPERATION
Note:
1. Set the axle in the upper position for the lowest cutting height, the
middle position for the medium height, and lowest position for the
highest cut.
2. All wheels must be at the same position.
3. The lowest cutting height is only suitable for trimming a very level, short
lawn. High and medium positions are recommended for normal use.
Never use the mower with the wheels set in different positions.
STARTING AND STOPPING
NOTE: The blade continues to rotate for a few seconds after the
machine is switched off. Allow the motor/blade to stop rotating
before switching “on” again. Do not rapidly switch off and on.
Starting:
1. Set the mower to the required ‘cutting height’.
2. Press and hold the safety button(6).
3. Squeeze the switch lever(7) towards the handle.
Stopping:
Release the switch lever.
Fig.4
Fig.5
Fig.6
