THE BOBBIN THREAD
1. Raise the needle to its highest position by rotating the
hand wheel toward you.
2. Remove the bobbin cover plate by pushing the
release button to the right. The bobbin cover will pop up
sufficiently to allow you to remove the cover.
3.Insert the bobbin making sure the bobbin rotates
counter- clockwise when you pull the thread.
4. Pull thread through the slot (A) and then to the left.
5. With a finger held gently on top of the bobbin, pull the
thread until it stops in slot (B). Then pull about 6" (15
cm) of thread and lead it towards back of the machine
under the presser foot.
NOTE: This is also a very important step to
assure the bobbin thread does not slip out of
position.
6. Replace the bobbin cover plate onto the needle plate.
NOTE: This is a very important step as the
bobbin can become unthreaded and cause
sewing problems if it rotates clockwise.
6
