BLAUBERG SMART, Инструкция по эксплуатации, Страница: 21 / 23

In this mode the fan runs with minimum air capacity before the humidity sensor,
motion sensor or external switch is activated.
Press the "24 HOURS" button on the control panel or the " “
button on the remote controller to activate this function. The green
indicator light under this button on the control panel confirms that this
mode is activated.
Press the button "24 HOURS" once again to deactivate "24 HOURS"
mode. This function is not available for the wiring diagram 2.
33
ACTIVATION OF MODE 24 HOURS
PAUSE
ACTIVATION / DEACTIVATION OF THE FAN
Push
21
Press the button "PAUSE" on the remote controller if you want to stop the fan for
45 minutes. After the timer countdown the fan reverts to the previous operation mode.
Press the button "PAUSE" once again to cancel the pause mode.
This function is controllable only from the remote controller.
RESET TO FACTORY SETTINGS
A built-in manual power slide switch is located in the fan side panel.
Turn the fan off with the slide switch, press and keep the button "MODE" on the control
panel and then turn the fan on again with the slide switch. After the fan is turned on,
keep the button "MODE" about 5 seconds until the light indicator stops blinking green.
3 4
Press the button " “ on the remote controller to deactivate the fan. The light on the fan
goes off and the fan does not response to any external factors as humidity change,
motion or closing of the external switch.
The interval ventilation function remains active - in 15 hours the fan is switched to 2 hours
to ventilate the premise.
This function is controllable only from the remote controller.