www.blaubergventilatoren.de
vento expert (Duo) a W v.2
12
VENTILATOR CONTROL
Turning ventilator on/off
Speed selection
Speed/off
The speed selection sequence
is follows: I-II-III-off.
Regeneration mode
The fan rotation direction changes to
opposite each 70 seconds.
This operation mode enables heat
regeneration.
Ventilation mode
Vento Expert
The ventilator runs in the extract or
in the supply mode at the set speed.
Vento Expert Duo
One fan runs in the extract mode and
the other one in the supply mode
at the same speed.
The air direction is not changed.
Party mode. Activation of the
speed III according to the timer
(the default setting is 4 hours).
Night mode. Activation of the
speed I according to the timer
(the default setting is 8 hours).
POSITIONING OF THE DIP SWITCH
Setup of ventilator operation mode
1
OFF: Master unit.
1
ON: Slave unit.
Standby mode setup
2
OFF: the ventilator is off in the Standby mode.
2
ON: the ventilator is running at the first speed in the Standby mode.
Setup of air flow direction in Ventilation mode with running ventilators for Vento Expert
3
OFF: the ventilator runs in the extract mode.
3
ON: the ventilator runs in the supply mode.
Setup of Boost mode (actuation of any sensor) for Vento Expert Duo
3
OFF: after sensor actuation the ventilator runs in the extract mode at the third speed
3
ON: after sensor actuation the ventilator runs in the current mode at the third speed
Reset to factory settings
4
OFF: standard operation mode
4
ON: reset to factory settings. Turn the switch to the position ON while the ventilator is running. After the sound signal turn the switch
to the position OFF.
The ventilator may be controlled with the following controls:
• infra-red remote controller
• the buttons located on the side of the indoor unit (see the figure below)
• the mobile application «Blauberg Vento V.2» installed on a smartphone or a tablet
