BLAUBERG Ventilatoren VENTO Eco A50-4 Pro1, Руководство пользователя

Страница: 10 / 20

www.blaubergventilatoren.de
vento eco
10
3.
Insert the sound absorbing roll in the air duct.
Before inserting the sound absorbing mat adjust its length with respect to
dimensions of the cartridge, indoor unit and ventilation hood.
Insert the cartridge during adjustment in the air duct and close it with
the internal grille. Roll the sound absorbing mat to match the air duct
diameter with the protecting paper layer outside. Insert the roll in the air
duct against stop to the cartridge.
Do not remove the paper layer!
1
2
50 mm (2”)
1
Ventilator with outer grille
Mark the point 1 on the sound absorbing mat on the level of the air duct
edge. Starting from the point 1 draw a line for 50 mm (2") and mark the line
2. Cut out the excessive part of the sound absorbing mat.
Insert the adjusted sound absorbing roll in the air duct.
Do not use any adhesives for fixation.
1
Ventilator with outer hood (optionally)
Mark the point 1 on the sound absorbing mat on the level of the air duct
edge. Cut out the excessive part of the sound absorbing mat.
Insert the adjusted sound absorbing roll in the air duct.
Do not use any adhesives for fixation.
4.
Install the air duct in the wall.
Fill the gaps between the wall
and the hole with a mounting
foam.
Foam wedge
min 3 mm
Install the air duct with the minimum slope of 3 mm downwards to the
outer wall side using the polystyrene wedges. Fill the gap between the air
duct and the opening with mounting foam.
5.
Route the cable though the cable hole and fix the back part of the indoor unit. Insert the cartridge in the air duct. Disconnect the
connector on the cartridge wire and connect the wires from the control panel to the mating part in compliance with the wiring
diagram in page 12. Connect the terminal block parts.
6.
Mount the front panel of the indoor unit and fix the outer ventilation hood.
Front part of the
indoor unit
Back part of the
indoor unit
Outer ventilation hood
(option)
For mounting guidelines please refer to the installation instruction for the outer hood.