BLAUBERG Ventilatoren Solo A35 S4 Pro R, Руководство пользователя

Страница: 10 / 16

www.blaubergventilatoren.de
Solo a35/50/60 S4 Pro r (v.2)
10
Switching the
ventilator on/off
Setting the first (lower)
fan speed
Setting the second (higher)
fan speed
Switching off the night
mode of the fan
Switching on the night
mode of the fan
Switching off the humidity
sensor
Switching on the humidity
sensor
60%
90%
Adjust the threshold of the
humidity sensor
Controlling the Solo A35 S4 Pro R V.2, Solo A50 S4 Pro R V.2, Solo A60 S4 Pro R V.2 ventilator using the remote control
The ventilator is connected to power mains using a cord with a plug.
The functions of the remote control buttons are shown in the figure below.
The speed at which the ventilator is currently operating is indicated by a coloured LED on the front panel of the indoor unit. The first
(lower) speed corresponds to the green colour, the second (higher) speed corresponds to the blue colour of the LED.
The passage of remote control commands is confirmed by a short-term decrease in the brightness of the LED on the front panel of the
indoor unit.
When switched on using the
On/Off
button on the remote control, the ventilator starts to operate at the speed at which it was switched
off.
When switched on using buttons
I
or
II
, the ventilator starts to operate at the corresponding speed.
If the humidity sensor is switched on, then when the humidity exceeds the preset level, the ventilator switches to the second (higher)
speed.
At high outdoor air humidity, the ventilator can switch to the second (higher) speed as a result of the humidity sensor triggering.
If such switching is undesirable, then temporarily turn off the humidity sensor using the remote control.
You can adjust the operating threshold of the humidity sensor by turning the potentiometer regulator using a special plastic screwdriver.
When turning on the night mode, the ventilator will operate at the first (lower) speed for 8 hours. At this time, the brightness of the LED
decreases and the ventilator does not respond to speed switching and triggering of the humidity sensor. After the end of this time period,
the ventilator will return to the previous operating mode. The night mode can be turned off at any time using the corresponding button
on the remote control.
DO NOT USE A METAL SCREWDRIVER, KNIFE, ETC. FOR ADJUSTMENT
OPERATIONS NOT TO DAMAGE THE CIRCUIT BOARD.