www.blaubergventilatoren.de
SE VENTO Expert W
7
1. Install the mounting box.
Installation inside a wall: make a niche in the wall, route the
necessary wires and cables to the control panel mounting
location and secure it in place.
Installation on a wall surface: route the necessary wires and
cables to the control panel mounting location, drill holes
and secure the box to the wall with self-tapping screws
(purchased separately).
2. Connect the control panel according to the electrical
connections diagram.
N
L
110-230 V / 50(60) Hz
3. Unfasten gently the latches on the lower part of the glass
control panel using a screwdriver. Take off the control panel.
Then disconnect the sensor board from the connector on the
casing.
4. Fasten the control panel casing to the mounting box with screws.
The screws used for fastening the panel to the mounting box are included with the unit.
5. Fasten the sensor board to the casing, and then the glass panel by pressing it until it clicks into place.