SE VENTO Expert W
6
www.blaubergventilatoren.de
Example 2
: connection via a router with a single Wi-Fi access point.
The control panel can be installed outside the range of the Wi-Fi access point built into the master ventilator.
Router
(Wi-Fi access point)
Master ventilator
(Wi-Fi access point)
Mobile device Mobile device
Control panel
(Wi-Fi client)
Control panel
(Wi-Fi client)
• Connect the router to the access point built into the
router (see the ventilator user’s manual).
• Bring the control panel within the range of the Wi-Fi
access point built into the ventilator.
• Pair the control panel with the ventilator (see below).
• Install the control panels within the range of the
Wi-Fi access point built into the ventilator.
Example 3
: connection via a router connected to several Wi-Fi access points.
Network cable
Router
(Wi-Fi access point)
Master ventilator
(Wi-Fi access point)
Mobile device Mobile device
Control panel
(Wi-Fi client)
Control panel
(Wi-Fi client)
Mobile device Mobile device
Control panel
(Wi-Fi client)
Control panel
(Wi-Fi client)
Supplementary
Wi-Fi access point
• Connect the router to one of the Wi-Fi access points
(see ventilator user’s manual).
• Pair the ventilator with the first group of the panels.
• Connect the ventilator to the other Wi-Fi access point
(see ventilator user’s manual).
• Pair the ventilator with the other group of the panels.
ATTENTION: IRRESPECTIVE OF THE SELECTED CONNECTION PATTERN THE PANEL MUST BE WITHIN THE RANGE OF THE
WI-FI ACCESS POINT BUILT INTO THE VENTILATOR DURING THE PARING OF THE CONTROL PANEL WITH THE MASTER
VENTILATOR.
PAIRING CONTROL PANEL WITH MASTER VENTILATOR
1. Set the ventilator to the Setup mode.
For more details see the ventilator user’s manual.
2. Set the control panel to the Setup mode.
Press and hold the
button for at least 5 seconds until the
buttons start blinking simultaneously. Pairing success is
confirmed by double blinking of all the control panel buttons. Upon successful pairing the control panel will exit the
Setup mode
immediately. If the pairing process fails to complete within 3 minutes, the panel automatically exits the
Setup mode
without altering
the initial settings.
3. Exit the ventilator Setup mode.
For more details see the ventilator user’s manual.
ATTENTION: THE PAIRING PROCESS MUST BE REPEATED AFTER EVERY CHANGE OF THE WI-FI PARAMETERS AND
VENTILATOR PASSWORD (SEE VENTILATOR USER’S MANUAL).
