Blastrac BMR-25P, Руководство по эксплуатации

Страница: 14 / 16

14
7. Blasthead
Blasthead Removal
1. Disconnect shot valve actuator wiring.
2. Remove blasthead belt guard.
3. Remove blasthead belt.
4. Remove the hydraulic cylinder pin.
5. Remove head pivot pin.
6. Roll the head away from the machine. Use CAUTION when removing the head. Be sure to support the
head so it doesn’t tip over.
Seal Adjustment
Front and side seals must be in contact with the ground at all times and the brush should be approximately ¼”
(6mm) from the surface. If the seals are not in contact with the ground, follow the steps below.
1. Loosen the nuts that hold the seals on. They don’t have to come all the way off, just loosen to where the
seals can move up and down freely.
2. Push seals down to where they contact the ground and tighten the nuts.
Shot Consumption Adjustment
If you notice that the dust collector is consuming shot, or if you are dropping shot, the vacuum needs to be
adjusted. To do this, follow the steps below.
1. Locate the vacuum slide plate on the driver’s side of the dust collector.
2. Loosen the knobs that hold the plate in place.
3. Slide the plate to the right, opening the plate, if you are consuming shot.
4. Slide the plate to the left, closing the plate, if you are dropping shot.
5. You will have to adjust the plate as necessary.
6. Once you have made the proper adjustments, tighten the knobs, locking the plate in place.