Blastrac BMP-E165, Руководство по эксплуатации

Страница: 26 / 52

Operating Instructions BMP-E165
Section 5 – Preparation and
Starting April 2006
©Blastrac April 2006 25
5.2 Starting (cont’d)
c) Connect the power cord to site power. Assure the fuse or circuit
breaker protecting this branch motor circuit does not exceed the
parameters set out in Section 2.5.
d) NOW, check the direction of rotation of the motor with the direction
marking (arrow) on the motor. This can be accomplished by quickly
turning the motor on and then back off.
e)
Start the motor by pressing the “On” switch.
f) The scarifying depth can now be set by means of the depth setting
adjustment wheel. Slowly increase the depth setting until the desire
surface profile is being obtained.
If excessive dust is generated, verify that the dust container of the dust
collector is empty and check the dust collector hose and connections.
If the scarifying depth is too deep it will have a negative effect on the
machine. Instead of more surface removal or scarifying, the
machine will run unevenly and may begin to “jump”.
By slight pushing or allowing the machine to “pull” itself along the
surface can now be worked with very minimal effort. The operating
speed, or the feed rate, will depend on the characteristics of the
surface and the desired surface profile to be obtained.