Blastrac 1-8DEZ, Руководство по эксплуатации

Страница: 28 / 62

Shot Blasting
MODEL 1-8DEZ BLASTER
SECTION 5
START-UP PROCEDURES & PRECAUTIONS
28
OPERATING MANUAL
JUNE 2007
5.1 START-UP PROCEDURES
WARNING: All operating and maintenance personnel must
read and understand the Operating Instructions before
attempting to operate or maintain the 1-8DEZ. In addition,
Blastrac highly recommends that all operating and
maintenance personnel receive training from an authorized
Blastrac representative before attempting to operate or
maintain the 1-8DEZ.
1.
The 1-8DEZ and the dust collector should be moved to the cleaning site.
Both machines can be hand-towed or moved by a lift truck.
2.
Put the 1-8DEZ in “Maintenance Mode” as described in Section 2.3.
3.
Check the dust bin of the dust collector to be sure that it is empty. At the
end of each job, the dust bin should be emptied.
4.
Check the blast wheel, control cage, feed spout, liners, seals and hopper
parts for wear. Replace parts where necessary.
5.
Check the exhaust hose for holes, deformities, potential leaks or
restrictions. Repair or replace all defective items before continuing.
6.
Connect the exhaust hose to the blast unit and the dust collector. Be sure
the clamps are secure, creating an air tight seal.
7.
All personnel in the area MUST wear safety glasses with side shields and
hearing protection.
8.
Verify that the main power switch located on the electrical box on the
steering handle is in the OFF position.
9.
Check the area you are about to clean. Be sure that it is dry and free of all
debris that can clog or damage the 1-8DEZ.
10.
Make certain that the abrasive control valve is in the closed position.
Remove the separator lid and check that the shot hopper is free of debris
and abrasive.