Blastrac 1-8DEZ, Руководство по эксплуатации, Страница: 11 / 62

MODEL 1-8DEZ BLASTER
OPERATING MANUAL
SECTION 2
SAFETY PRECAUTIONS
JUNE 2007
2.3 MECHANICAL SAFETY INSTRUCTIONS
Maintenance Mode
Maintenance mode is defined as the state or condition of the 1-8DEZ, which
minimizes mechanical and electrical hazards.
The 1-8DEZ should be put into maintenance mode prior to making adjustments
or attempting any maintenance. The steps for placing the 1-8DEZ in
maintenance mode are listed below.
1. Move 1-8DEZ to level ground.
2. Turn off main power at electrical box located on steering handle.
3. Verify all moving parts have stopped.
4. Release grinder power trigger by simultaneously pressing the grinder
power trigger and unlock button located on the back of the grinder.
5. Utilize Lock-Out/Tag-Out procedures on main power on/off switch on the
electrical box located on the steering handle.
Most industrial and many commercial work sites will have their own Lock-
Out/Tag-out procedures. The site safety personnel should be contacted to
establish the procedure to be used. If the site has no formal Lock-out/Tag-out
procedure, the operators of this 1-8DEZ should be prepared to implement their
own procedure, including training of all operating and maintenance personnel.
All drive guards must be kept in place and in good condition except during
maintenance or when repair work is being performed. Once maintenance or
repair work is complete, be sure all guards are securely remounted and
operating.
Safety glasses with side shields and hearing protection must always be worn
when working with or near the 1-8DEZ while in use.
Loose fitting clothing should not be worn when working with the 1-8DEZ. Gloves
can be worn for added protection, however loose fitting gloves could be
dangerous.
The 1-8DEZ and all areas around the 1-8DEZ should be kept clean. Loose
media in particular can become hazardous for foot traffic. All abrasive leaks
should be stopped immediately to help keep the work area free of spilled
abrasive.
Any condition(s) that may result in damage to the 1-8DEZ or cause injury to the
operator and/or other personnel should be repaired immediately.
Shot Blasting
11