Blaser BL 30, Инструкция по эксплуатации, Страница: 13 / 44

8. Position the recoil lug with the groove on the sliding block and insert
the attachment screw. (Figure
6
)
Note: For B2 with fixing for the cross bracket, insert this forwards in
the direction of fire.
• Fix the sliding block with the recoil lug by fastening the attach-
ment screw, rotating it fully twice.
9. Slide the pre-fixed recoil lug up to the front stop position on the
inner rail and tighten the attachment screw by hand (around 3 Nm).
(Figure
7 )
10. Then move the attachment mount onto the Blaser B1 1-7x28 iC /
Blaser B2 1-6x24 iC lens.
• Align the attachment mount with the outer contour of the
riflescope casing. The attachment mount will then automatically
position itself thanks to the form fit between the riflescope casing
and attachment mount.
• In doing so, ensure that the release lever is in the open position
and points horizontally in the direction of fire. (Figure 8 )
11. Push the device, including the attachment mount, onto the Blaser
B1 1-7x28 iC / Blaser B2 1-6x24 iC as far as it will go and turn the
release lever 90° clockwise.
The cross bracket controlled by the release lever now engages into the
recoil lug and secures the attachment mount against removal.
(Figure
9 )
12. To fix it completely, close the release lever to lock the attachment
mount onto the Blaser B1 1-7x28 iC / Blaser B2 1-6x24 iC lens.
• Adjust the clamping force so that the release lever can be fully
closed and opened again with your thumb. (Figure 10 )
• Close or open the rear star screw to increase or decrease the
clamping force. (Figure 11 )
The attachment mount is now installed in position and can be used.
EN
13