DRD 700 Quad Multistream Processor
Rev. D
www.blankom-digital.de
Page 7 (26)
Control with display and navigation wheel
The display is showing the most important status information and the navigation wheel allows the
configuration of the LAN connection. All configurations are made by turning and pressing the navigation
wheel located at the front of the device at the right side. By turning the wheel, the user can navigate
through the entire menu. The selected menu is shown inversely. You can select the menu by simply pressing
the navigation wheel.
If the navigation wheel is not operated for 30 minutes, the display illumination is automatically switched off.
If you start a new operation, the lights will be switched on once again!
Configuration mode (CFG)
For changing the configurations, the user must select “CFG” in the corresponding menu and keep the wheel
pressed for at least 3 sec. until a * appears behind “CFG”. Then, the user can select the corresponding
parameters with the wheel, which are presented with a blinking display.
You can now change the configuration with the navigation wheel. If a parameter is changed “SAVE” appears
in the display; by pressing the navigation wheel, this parameter can be selected for saving. “SAVE” is
displayed inversely; the configuration is saved in the device by simply pressing the wheel.
After 30 sec. the configuration mode is switched off automatically if the navigation wheel is not in use.
Operation display
If an input signal is connected the the state of the
signal is indicated.
Description of menu
The main menu items can be selected with the navigation wheel. By pressing the wheel, the user navigates
to the sub-menus, which are selected in the same manner. The configurations can only be changed in the
configuration mode (select “CFG” and press the wheel for at least 3s).
Main Menu
Sub-menu
Parameter
Description
Logbook
Events
Display of all 512 logbook entries
Erase
Erase all logbook entries
System
Reset/Preset
Reset:
Restart with stored parameters
Preset:
Restart with factory settings
Attention:
Preset resets the IP addresses to
default
Version
Display of the device type, SW versions and serial no.
LCD Contrast
Configuration contrast of display
LAN
Control
IP address
(192.168.0.200)
Subnet mask
(255.255.255.000)
Gateway address
(192.168.0.001)
MAC address
Display
