DRD 700 Quad Multistream Processor
Page 10 (26)
www.blankom-digital.de
Rev. D
Input-DVB-S/S2 (Option)
The selection of the input source DVB-S/S2 will show the following configuration menu, where you can
configure the parameters required for DVB-S/DVB-S2. Click
Set
to transfer the configured data to the
device. By this the SAT-ZF DVB-S/S2 signal is selected as the input signal. ASI and IP Input are disabled.
The symbol rate must be precisely specified. By pre-selecting the DVB-S or DVB-S2 mode the tuning
procedure of the DRD 700 is accelerated. However the usual mode of operation is AUTOMATIC.
The menu items 'LNB Voltage' and 'LNB 22 kHz Tone' can be configured accordingly.
The SCPC mode should be enabled if a narrow-band transport stream (< approx. 5 Msps) has to be received
and if there are several narrow-band transport stream on the transponder at the same time. By entering the
transport stream ID (SCPC TSID) it is ensured that the DRD 700 tunes on the selected transport stream.
The TSID must be entered in hexa-decimal format.
