25
When listing the output parameters for each channel the
available brutto bit rate, the used channel bit rate and the
possibly existing overflow bit rate are displayed.
The used channel bit rate should be
smaller
than the
brutto bit rate. Otherwise it can cause disturbances or
even failure of the transferred services.
Check therefor the utilization and possibly reduce the
number of transferred services when setting the channel
assignment in menu “
Multiplexers
“ (
»chapter 7.2.3
).
The individual services and their status are listed by clicking
the check box in front of “
Services
“.
When listing the system parameters the parameters of the
device and of the media player are displayed.
7.2.11 Menu “Amplifier“
The amplifier can be set and used independently of
the device. It does not influence the device itself or
other devices of the headend. The adjustment range of
amplification is between 15 .... 35 dB.
• amplifier deactivated:
• amplifier activated:
power consumption
0 W
power consumption
+14W
output level with loop
60 ... 78 dBµV
output level without loop
72 ... 90 dBµV + amplification (15 ... 35)
without loop
72 .... 90 dBµV
• internal SBL mode
The amplifier is fixed at +21 dB and is automatically integrated into the level display menu.
Thus the max. output level is at 114 dBµV.
In view of the deterioration of the signal to noise ratio the use of loop is not recommended.
• SET reference
The actual applied level is set as a reference. The status menu displays the level deviation of a value during operation.
