23
EN
22
EN
13/ CLEANING YOUR APPLIANCE
Fig. 15
The filtration system consists of several
elements:
--
The waste filter
--
The large main filter
--
The micro filter
The filters are located in the centre of the tub
and must be washed regularly to obtain opti-
mum washing results.
Actions :
➀
➀
Before removing the filters, remove any
waste on the large main filter
with a
sponge so that the waste does not block the
sprinkler arms. Rotate the spray arm as
shown in the drawing. (Fig. 14)
➁
➁
Loosen the waste filter a quarter of a turn
and then remove it
③
③
Remove the main filter
④
④
Remove the micro filter
⑤
⑤
Carefully clean filters
,
and
under running water (Fig. 15)
Re-installation:
Proceed in reverse order, inserting filters
and and
then
Important :
Remember to lock the waste filter
in place by pushing it in fully and turning it a
quarter turn.
A
A
A
A
B
B
C
C
C
C
B
B
A
A
C
C
B
B
A
A
B
B
C
C
B
B
A
A
• CLEANING THE WASTE FILTERS
Fig. 14
A
A
B
B
C
C
➁
➁
③
③
④
④
⑤
⑤
12/ YOUR DISHWASHER’S SAFETY SYSTEMS
•
Door poorly closed
After confirming the programme (“Start” button), your dishwasher issues three short high-pitched
beeps to indicate that the door is not closed and the light for the selected programme flashes.
•
Programme access lock
Throughout the period the programme is running, or the full duration of the programme, the
programme selector and the buttons are automatically protected from any kind of manipula-
tion. This unlocks automatically at the end of the programme or when the programme is can-
celled by holding down the “Start” button for 3 seconds.
•
Advice on cleaning the filters
Approximately every month, your dishwasher advises you to proceed to service the
filters (see Section “Cleaning the waste filters” - Fig. 14-15).
•
Anti-overflow system
This system activates the drain pump automatically if the water in the tank reaches an abnormal
level.
•
Anti-leak protection system
This system cuts off the water supply if a leak is detected under the appliance.
•
Total safety
This supply pipe is fitted with a device to cut off the water supply directly at the tap if there is a leak.
•
Alarm light
For programme errors or incidents (please refer to Section 14 "If an operating abnormality
occurs").
NB:
To unlock, hold down the Start / Cancel button for three seconds.
• SAFETY SYSTEMS
A
A
C
C
B
B
➀
➀
A
A
B
B
C
C
