17
EN
16
EN
9/ SETTING THE PARAMETERS
8/ YOUR DISHWASHER’S EQUIPMENT
Movable grills are available for if you wish to
load your cutlery in an orderly manner
(Fig.
13).
For optimum washing and drying, use these
separation grills partially or totally.
Point the handles on the cutlery downwards.
Important :
For safety reasons, we recommend
that you place knives with pointed ends with
the point facing downwards in the cutlery
basket (to avoid the risk of an accident).
Long-bladed knives and other sharp kitchen
utensils must be placed flat in the upper bas-
ket.
Avoid washing cutlery with horn handles in
your dishwasher.
Separate silverware from other metals using
the separation grill.
• THE CUTLERY BASKET
Fig. 13
The cutlery basket slides to allow flexible
loading.
It can be placed anywhere in the lower basket.
You can therefore make a variety of loads
depending on the items (Fig. 12).
If your cutlery items or your dishes are too
large, alter the height setting for the upper
basket.
Fig. 12
• SETTINGS POSSIBLE USING THE “SET” AND SELECTION BUTTONS:
1 long
press
•
1 long press on the “
S
ET
”
button and then a short press
enables you to move on to the following parameters.
Set the parameters by pressing one of the programme
selection buttons or the other.
Move on to the next parameter by pressing “S
ET
”.
Display
Briefly
press
the “SET”
button once
and then
press one
or
other of the
selection
buttons
Advice:
The setting is confirmed automatically when you move on to the next parameter or if the
“Set” button is not pressed again within the next 10 seconds.
> Setting the clock (hour)
To do this, hold down the “S
ET
” button. When the
time starts to flash, press one of the selection but-
tons or the other until you reach the desired time.
Press S
ET
to move on to the next parameter.
> Setting the clock (minutes)
Proceed in the same way as above; press one of the
selection buttons or the other to set the minutes.
> Setting the water softener
Set to the level corresponding to the hardness of
your water:
H
H0
0
to
H
H6
6
.
> Product use
You can cancel display of the relevant indicators,
depending on the products used:
- Salt
Set to
O
OF
FF
F
if you do not use salt or f you
are using multi-purpose tablets.
- Rinsing product
Set to
O
OF
FF
F
if you do not use a
rinsing product or if you are using multi-purpose tablets.
> Multipurpose tablets and the
“AUTO 4/1 ” function
- For optimum product performance (depending on
the water softener setting table on page 11), set:
-
to deactivate the “AUTO 4/1” function.
-
to activate the “AUTO 4/1” ““E
Ex
xttrra
a D
Drry
y”” func-
tion (default selection)
-
to activate the “AUTO 4/1” ““S
Sp
pa
arrk
klliin
ng
g C
Clle
ea
an
n””
function.
> Beep at the end of the programme
O
On
n
to activate the function;
O
OF
FF
F
if you do not wish not
to hear the beep at the end of the program.
> Screen brightness
Set the screen brightness to suit yourself from
L
Lu
u11
minimum to
L
Lu
u5
5
maximum.
o
orr
