BLADEZ XTR-HD, Руководство по продукту

Страница: 9 / 16

Page 9
Charging
Your XTR-HD should come charged out of the box. Bladez still recommends charging
the unit for 6-8 hours prior to first use! Bladez also recommends charging your XTR-HD
after every use and prior to storage.
Warning: DO NOT allow your Powerboard to go into deep
discharge! – This will damage
the batteries.
Charging Instructions
Charging
1. Carefully remove the XTR-HD from the box.
2. Make sure the unit is turned OFF.
3. Open the charging plug by rotating the safety
cover counter clockwise as shown in arrow
from Fig. 6.
4. Turn on the charger by switching the on/off
button on the back of the charger.
5. Locate the AC CHARGER and plug it into
wall. Insert the charger (the end with the
prongs inside of it) into the charging plug. A
red light will come on the Charger indicating
that the charger is turned on (Fig. 7). The
light next to the red light indicate the
charging status of your Power Board.
The charging light indication is shown on top of the
charger as shown in Fig 8.
= Charging
= Full charge
= Disconnect
6. Remove charger and close the safety cap.
7. You are now ready to ride the XTR-HD.
Note: If the light turns green right away, this is because the unit was charged at the
factory. Please continue charging for 6-8 hours prior to initial use.
Fig. 6
Fig. 5
Fig. 7
Fig. 8
Status light
Power On light