BLADEZ PB-SM1816, Руководство по продукту

Страница: 12 / 16

Page 12
Adjusting the Brakes
The Brakes on the XTR-Street II should come fully
adjusted from the factory. However, it may be
necessary to adjust the brake from time to time.
To adjust the brakes:
Loosen the tension screw on the Brake Lever by
rotating it counter-clockwise until the wheel spins
freely, with some For further adjustment:
1. With one hand, depress the brake calliper using your thumb and forefinger.
(Fig. 13)
2. With the other hand, adjust the tension screw on the brake line.
a. Turn the tension screw clockwise to loosen the brake.
b. Turn the tension screw counter-clockwise to tighten the brake.
Squeaky Brakes
The brakes may squeak before they are broken in. This is normal and will not affect the
function or performance of the brakes. With continued use, the squeak should go away.
TIRES AND WHEELS
The Bladez XTR-Street II uses an identical rim and tires assembly on the front and rear
wheels, which means that the tires can be rotated. The wheels are actually two wheel
halves (split rim) bolted together to make it easier to remove and replace the tire.
The rear wheel is fitted with a special spacer to accommodate the sprockets, while the
front wheel has a bracket for the disc brake.
Tire wear will differ based on rider weight, riding conditions and care. Replacement tires
can be obtained at your local Bladez dealer, through motorcycle shops, or from the
Bladez website at
www.ebladez.com .
Tire Pressure
This pneumatic tire must be inflated to a maximum of 57 P.S.I.
Empty all air from the tire, prior to loosing the bolt to split the rim.
*Always make sure that your tires are fully inflated. If the tire pressure is low is will
cause the scooter to run at slower speeds and consume more battery power.