BladeZ Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610
www.ebladez.com
• Phone 949-206-8152 • Fax 949-206-0013
14
SECTION 4
OPERATION
Startup Display
All windows will display 0 after power on, and the matrix window will display
”Start”.
Operation
1. Under Start/Ready mode, the LCD panel will display ”Start”. In this mode,
the user can enter the function edit mode by pressing SELECT, and at the
same time, the word PROGRAM will appear and blink.
2. When the word PROGRAM appears and blinks, press SELECT again and
the LCD panel will show Count Up, Count Down, P-1, P-2, P-3, P-4, P-5, P-
6 and HRC in sequence.
3. When the desired mode is displayed, press ENTER to edit the detailed
functions.
4. After the function is set, press START to enter RUN mode.
5. In RUN mode, if you press STOP, then you will enter Pause mode, if you
hold STOP for 3 seconds it will go back to the Start/Ready mode.
Program Operation and Instructions
Detailed edit method of each mode.
Automatic start function:
In Start/Ready mode or edit mode, if the sensed rotate speed is over 20 RPM,
it will start automatically, and its status is the same as pressing the start key in
that case.
Count Up (count up mode):
(1) This mode has no detailed item to edit, so press ENTER key under Count
Up mode and it displays Ready.
(2) Press START key to enter RUN mode and the LCD panel displays time
counting up from 0 to 99 minutes.
(3) Press SELECT key in RUN mode. The matrix window will display miles/h