7
EN
Using the Video Transmitter
Adjusting the FPV Camera Angle
Band
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
Band A
5865
5845
5825
5805
5785
5765
5745
5725
Band B
5733
5752
5771
5790
5809
5828
5847
5866
Band E
5705
5685
5665
5665
5885
5905
5905
5905
FS/IRC
5740
5760
5780
5800
5820
5840
5860
5880
RaceBand
5658
5695
5732
5769
5806
5843
5880
5917
Consult local laws and ordinances before operating FPV equipment. In some
areas, FPV operation may be limited or prohibited. You are responsible for
operating this product in a legal and responsible manner.
See the Available Frequency table to fi nd the desired video channel and band.
The video transmitter channel and band are changed using the button on the
top of the video transmitter board, as shown. There are two rows of LEDs
visible on the board. The inner row of red LEDs indicates the channel selected
(1-8). The outer row of blue LEDs indicate the selected band
(F, E, A, R, B). The bottom green LED indicates if the board is transmitting.
Only change the video channel and band when the video transmitter is not trans-
mitting a signal. If the green LED is glowing solid, see the directions below to stop
transmitting a video signal prior to changing the channel or band.
Channel Selection:
1. With the video transmitter powered on, press the the channel button
once per channel to cycle through the channels.
2. The current channel (1–8) is indicated by which channel LED is lit.
Band Selection:
1. With the video transmitter powered on, press the channel button quickly
twice to change the band.
2. The current band (F, E, A, R, B) is indicated by which band LED is lit.
Video Signal on/off:
1. Press and hold the channel button for 2 seconds to start transmitting a video signal, indicated by the green LED glowing solid.
2. Press and hold the channel button for 2 seconds to stop transmitting a video signal, indicated by the green LED turning off.
Available Frequencies, North America (mHz)
The angle of the FPV camera is adjusted by loosening the
two screws holding the camera to the mount and rotating the
camera to the desired angle. Tighten the screws to secure
the camera. Do not overtighten the screws as damage to the
camera or mount may result.
Video Transmitter LEDs
Channels
1-8
Bands
Channel
button
LEDs
