5
EN
Transmitter Setup
Timer
Mode
Count Down
Time
3:00
Start
Throttle Out
Over
25%
One Time
Inhibit
Servo Setup
Chan
Travel
Reverse
THR
150/150
Normal
AIL
148/148
Reverse
ELE
148/148
Normal
RUD
148/148
Reverse
GER
100/100
Normal
AUX1
100/100
Normal
FUNCTION LIST
D/R & Expo
Chan
Switch Pos
D/R
Expo
AILE
0
100/100
0
1
100/100
0
2
100/100
0
ELEV
0
100/100
0
1
100/100
0
2
100/100
0
SETUP LIST
F-Mode Setup
Switch 1
Inhibit
Switch 2
Inhibit
Model Type
Airplane
Channel Assign
Channel Input Confi g
1 Throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear
Switch B
6 Aux 1
Switch H
Frame Rate
11ms*
DSMX
DX6, DX6e, DX7 (Gen 2), DX8 (Gen 2), DX9, DX18, DX20
Switch Functions
Flight Mode Switch =
Switch B
Motor Arm Switch =
Switch H
Installing the Flight Battery
CAUTION:
Always disconnect the Li-Po battery
from the quadcopter when not fl ying to avoid
over-discharging the battery. Batteries discharged to
a voltage lower than the lowest approved voltage may
become damaged, resulting in loss of performance and
potential fi re when batteries are charged.
* The DX6e operates at 22ms frame rate and cannot be changed.
1. Set the motor arm switch to OFF (position 1).
2. Lower the throttle.
3. Power on the transmitter.
4. Attach hook material to the quadcopter frame and loop
material to the battery.
5. Install the fl ight battery on the quadcopter frame and
secure it with the hook and loop strap.
6. Connect the battery cable to the aircraft power lead, noting correct
polarity. Do not move the quadcopter until the receiver initializes.
CAUTION:
Connecting the battery to the aircraft
power lead with reversed polarity will cause
damage to the power distribution board, ESCs and the
battery. Damage caused by incorrectly connecting the
battery is not covered under warranty.
7. The quadcopter motors will emit initialization tones,
indicating the ESC is armed.
To download the setup fi le for the Spektrum
™
DXe transmitter, refer
to
www.spektrumrc.com.
For telemetry setup information, refer to your transmitter manual or
www.spektrumrc.com
.
