9
EN
RTF
Transmitter Control
ON
1 2 3 4 5 6 7 8 9 10
F
G
H
E
A
D
C
B
Flight Mode Switch
0 = Beginner Mode
1 = Intermediate Mode
2 = Experienced Mode
H
A
B
C
D
E
F
G
H
Mode 1
Power LED
Aileron
(Left/Right)
Throttle
(Up/Down)
Throttle
Trim
Aileron
Trim
ON/OFF
Switch
Rudder
Trim
Elevator
Trim
Rudder
(Left/Right)
Elevator
(Up/Down)
Mode 2
Power LED
Aileron
(Left/Right)
Elevator
(Up/Down)
Elevator
Trim
Aileron
Trim
ON/OFF
Switch
Rudder
Trim
Throttle
Trim
Rudder
(Left/Right)
Throttle
(Up/Down)
Bind/Panic
Switch
Dual Rate Switch
Back = High Rate
Forward = Low Rate
Volts Display
RTF
Change fl ight modes by moving the three-position fl ight
mode switch. Ensure the fl ight mode switch is in the desired
position before fl ying.
• In Beginner Mode (switch position 0), the bank angle is
limited to 15 degrees. When the cyclic stick is released,
the model will return to level.
• In Intermediate Mode (switch position 1), the bank angle
is limited to 35 degrees. When the cyclic stick is released,
the model will return to level.
• In Experienced Mode (switch position 2), the bank angle
is not limited. When the sticks are released, the model will
not return to level. If you lose orientation, use the Panic
Switch to return the model to a familiar orientation.
Change rates by moving the two-position dual rate switch.
• Low rate reduces the control rates, providing an easier to
fl y model. Beginners should use low rate for initial fl ights.
• High rate provides full control and should be used by
intermediate and experience pilots.
Refer to the
Transmitter Setup Table
for which switch on your transmitter selects fl ight modes and specifi c setup information.
Flight Mode and Rate Selection
Flight mode
switch
Dual rate
switch
