12
EN
Return Home
NOTICE:
Return home will only function if the
350 QX3 has GPS lock.
• When this feature is activated, the LED will rapidly
fl ash red.
• The 350 QX3 will fl y back to its assigned home loca-
tion and land. After landing, the motors may take up
to 5 seconds to stop.
• The return home function may be cancelled by
switching back to Smart or AP Mode using the fl ight
mode switch.
• To restart the props after landing in Return Home,
move both transmitter sticks to the bottom inside
corners and then back to center.
CAUTION:
The 350 QX3 will not recognize the
SAFE Circle
feature when Return Home is used.
Activating Return Home may cause the 350 QX3 to
fl y directly over the pilot if the aircraft was fl own to a
position behind where the pilot was standing when the
home position was established.
Activating Return Home
Landing
To land the 350 QX2 AP there are two options:
• Guide the aircraft to where you wish to land. Slowly
reduce the throttle below half to descend and land.
When the quadcopter has landed, lower the throttle
completely and press the bind button to stop the
motors.
• Activate the Return Home function to return the
350 QX3 to the assigned home location and land
automatically.
CAUTION:
Do not activate the
Return Home
function if the 350 QX3 is showing the low
battery indication.
Manually land the aircraft
immediately.
After Your Flight
1. Turn off the power switch on the 350 QX3.
2. Turn off the power to your transmitter.
3. Unplug and remove the battery from the 350 QX3.
Recharge your battery following the charging
warnings and instructions.
CAUTION:
Always disconnect the Li-Po bat-
tery from the aircraft when not fl ying to avoid
over-discharging the battery. Batteries discharged to a
voltage below the lowest approved voltage may become
damaged, resulting in loss of performance and potential
fi re when batteries are charged.
Location alert
The motors will beep under the following conditions:
• At any time the props stop spinning after they have
been initialized.
• After 30 seconds of no throttle input (waiting armed
on the ground).
This will alert the pilot to the location of the aircraft if it
lands in a location with low visibility.
Beeping will continue until the battery can no longer
supply enough power to the motors.
If the quadcopter crash lands and one or more motors
are stopped by an impact, the quadcopter enters
emergency mode. The LED will fl ash white and the
motors will beep loudly.
b
a
Motor Stop
Содержание 350 QX3
Страница 1: ...I N S T R U C T I O N M A N U A L ...
