Blade 350 QX3, Инструкция по эксплуатации

Страница: 8 / 16

8
EN
Binding
The RTF/AP combo transmitter is bound to the model
at the factory. If for any reason the model needs to be
re-bound, follow the directions below.
Normal Bind
Roll left
Roll right
Bind with GPS enabled
Bind with GPS disabled
Bind button
Transmitter Bind Codes
Entering Bind Mode
Binding the 350 QX3 To Your Transmitter
1. With the transmitter and quadcopter powered OFF,
connect the battery to the 350 QX3.
2. Place the 350 QX3 on a fl at level surface.
3. Power the 350 QX3 ON and let it initialize. The
status LED will remain off.
4. Hold the 350 QX3 upside down until the status LED
fl ashes blue, indicating it has entered bind mode.
5. Set the quadcopter back upright.
6. On your transmitter, ensure the throttle is in the low
position and the throttle trim is at neutral.
7. Power ON your transmitter in bind mode according
to the instructions included with your transmitter.
8. When the binding process is successful, the
350 QX3 will emit a quick, 3-beep tone and the LED
will fl ash either green, purple or red, depending on
which fl ight mode is selected.
If the LED is fl ashing red, the 350 QX3 is in Return
Home mode. Switch to Smart or AP Mode (green
or purple fl ashing) before attempting to start the
motors.
9. Place the quadcopter outdoors in the desired
starting position in preparation for fl ight.