Blackmagicdesign ATEM Mini, Инструкция по установке и эксплуатации

Страница: 140 / 2014

HyperDeck Setup with ATEM 1 M/E Advanced Panel
Once you have connected your HyperDeck to your switcher, as detailed in the ‘connecting
HyperDecks’ section, use ATEM 1 M/E Advanced Panel’s system control and LCD soft buttons
to setup and control your HyperDecks.
To begin, press the system control ‘settings’ button.
You’ll notice that ATEM 1 M/E Advanced Panel displays four setup options along to top of the
LCD screen. These include ‘switcher,’ ‘panel,’ ‘HyperDecks,’ and ‘button mapping.’
Each corresponds to a setup menu. Simply press the LCD soft button above ‘HyperDecks’ to
enter the ‘HyperDeck settings’ menu.
The HyperDeck settings menu has three pages, which you can select using the ‘left’ and
‘right’ arrow buttons in the system control panel, or by pressing the ‘1,’ ‘2,’ and ‘3’ buttons on
your ATEM 1 M/E Advanced Panel’s numerical keypad.
Assigning an input to a HyperDeck
In the first menu page, you’ll see the ‘HyperDeck’ indicator in the bottom left corner, and an
‘input’ indicator.
Use the control knob under the ‘HyperDeck’ indicator to cycle through the available
HyperDecks.
Once you have selected a HyperDeck, simply rotate the knob under the ‘input’ indicator to
select which input that HyperDeck is connected to on your switcher. For example,
if HyperDeck 1 is connected to input 4 on your switcher, rotate the knob under the ‘input’
indicator to select ‘camera 4.’ Press the ‘input’ knob to confirm your selection.
Repeat this process for
any additional HyperDecks
you have connected to
your switcher by assigning
inputs to HyperDeck slots
1, 2, 3 and 4, if required.
Assigning an IP Address
Once you’ve assigned an input to a HyperDeck, you’ll need to enter its IP address.
This allows ATEM 1 M/E Advanced Panel to control the HyperDeck via Ethernet.
140 HyperDeck Control