Blackbox ACS253A-CT, Инструкция по эксплуатации, Страница: 19 / 68

OVERVIEW
19
2.6 How to Use This Guide
This guide describes the installation and configuration of the ServSwitch

Brand DVI KVM
Extender Series. Although the connection and operation of the system is relatively
straightforward, you should consider the following before getting started:
Connection & Compatibility
If you have purchased an Extender Kit , this will contain all the cables required to connect the
Local unit to your PC or KVM switch. The Remote console (keyboard, monitor and mouse)
and any audio and serial equipment connects directly to the Remote unit.
For information about connection and installation, see Installation , page 20.
Interconnection Cable
For ACS253A-CT Extenders, you will need CATx (any category 5, 5e, 6 or higher) cable,
terminated with RJ45 plugs, to connect the Local and Remote units. Other units require
singlemode or multimode fibers (see
Interconnection Cable Requirements , page 21.
Adjusting Video
Due to the digital nature of the transmitted signals, there is no distortion of video signals or
skew problem even with CATx interconnection cables.
If you do not have a DVI source and a DVI monitor, you will need to adjust the monitor
and/or the Extender to the picture width and the pixel phase. You can do this using the Auto
Adjust or Manual Adjust procedures (see page 41).
•
For experienced users there is a Quick Setup section at the start of this guide
(see page 11).
•
For the full procedure, see Monitor Setup (page 40) and/or Extender Setup (page 41).