User Manual 3D-Printer
Version 2018-3.1_ENG
17
5.6
Calibrate the belt
In this procedure we need to touch the belt with the hands. Make sure that you have clean hands with no
grease on them to keep the conveyor belt clean.
1.
Make sure that the conveyor belt is in between the limitations.
[1-2]
a.
Check the tension of the belt. Pull up the belt mid between the front roller and the front build plate.
b.
With a decent pull of your index finger you should not be able to pull it higher than the build plate.
If you can pull it higher, tighten the rear screws a bit more, so its levels with the build plate.
2.
Turn the belt manually by hand in the printing direction.
[3-6]
a.
If you notice the belt going towards one of the limitations, tighten that side for half a rotation and
loosen the opposite side for half a rotation
3.
Repeat step 2 until the belt does not move to one of the sides
4.
Check the bel tension once again, make sure that you cannot lift the belt above the build plate
[2]
1
2
3
4
23
24
0
