4
REMOTE AUTO START
Optional Keyless Entry Instructions Included
BEFORE YOU BEGIN
This system is compatible with electronic
fuel injected engines only! Not intended for
use with carbureted engines.
• This product must be installed by qualified
personnel according to these instructions and
and observing all safety features.
• Check to see if the vehicle is equipped with
any type of factory security system.
• Check to see if there is a pin switch for the
hood, if not one must be installed.
• Verify that the vehicle starts and idles
properly before beginning the installation.
• Always use a multi-meter to verify wiring.
• Before mounting the product, verify with the
customer the desired location for the window
mount receiver.
MOUNTING SYSTEM COMPONENTS
Mount the start module under the dash where
it will be away from moving parts such as brake
pedals, etc. Mount the receiver to the inside of
the windshield using the supplied double-sided
tape. Make sure the chosen location does not
obscure the driver’s view.
MODULE WIRING
12-Pin Main Harness
• YELLOW WIRE - Factory Alarm Arm output
(-) 250mA. Connect to the wire that requires a
ground pulse to arm the factory alarm. The
YELLOW wire provides a ground pulse when
the remote transmitter is used to lock the
doors or when the remote start shuts down.
See
Programmable Features
• RED/WHITE WIRE - Auxiliary / trunk release
output (-) 250mA. Connect to a relay for an
optional feature such as trunk release. The
RED/WHITE wire can instead be programmed
for use as a negative parking light output if
needed, and the WHITE positive parking light
output then becomes a positive trunk release
output. See
Programmable Features
• BROWN WIRE - Factory Alarm Disarm
output (-) 250mA. Connect to the wire that
requires a ground pulse to disarm the factory
alarm. The BROWN wire provides a ground
pulse when the remote transmitter is used to
unlock the doors or start the vehicle.
• ORANGE WIRE - Ground when running /
Anti-grind output (-) 250mA. The ORANGE
wire can be also programmed for use as a
Starter Defeat output with Anti-grind or as a
passive Starter Defeat output that activates 30
seconds after the ignition is turned off.
Ground when running (default): Provides a
ground when the remote start is activated and
is normally used to activate an optional factory
security bypass module, a relay for anti-grind, a
3rd ignition relay, etc.
Starter defeat w/ anti-grind: Provides a ground
when the remote start is activated and when
button 1 is used to lock the doors.
Starter defeat w/ passive operation: Provides a
ground to activate a starter defeat relay 30
INSTALLATION INSTRUCTIONS
BEFORE INSTALLING THIS PRODUCT PLEASE READ
THE INSTALLATION DIRECTIONS THOROUGHLY!!
BW651 final.qxd 10/18/2005 10:58 AM Page 4
