11
Burner Flame Check
Light burner, rotate knob from high to low. You
should see a smaller flame in low position than
seen on high. Perform burner flame check on side
burner, also. Always check flame prior to each use.
If only low flame is seen refer to “Sudden drop or
low flame” in the Troubleshooting.
Turning the Tailgater Off
Turn knob to the OFF position. Turn LP
cylinder OFF by turning hand-wheel clockwise to a
full stop.
Valve Check
Important: Make sure gas is off at LP cylinder be-
fore checking valves. Knobs lock in OFF
position. To check valve, first push in knob and
release, knob should spring back. If knob does not
spring back, replace valve assembly
before using the Tailgater. Turn knob to low posi-
tion then turn back to OFF position. Valve should
turn smoothly.
Hose Check
Clean and inspect the hose before each use of the
appliance. If there is evidence of abrasion, wear,
cuts or leaks, the hose must be replaced prior to the
appliance being put into operation. Use only identi-
cal replacement part valve/hose/regulator as speci-
fied in the Parts List of this Use and Care Guide.
General Tailgater Cleaning
•
Do not mistake brown or black accumulation
of grease and smoke for paint. Interiors of gas
ovens are not painted at the factory (and should
never be painted). Apply a strong
solution of detergent and water or use an oven
cleaner with scrub brush on insides of oven lid
and bottom. Rinse and allow to
completely air dry. Do not apply a caustic griddle/
oven cleaner to painted surfaces.
•
Plastic parts: Wash with warm soapy water and
wipe dry. Do not use Citrisol, abrasive
cleaners, de-greasers or a concentrated oven
cleaner on plastic parts. Damage to and failure of
parts can result.
•
Painted surfaces: Wash with mild detergent or
nonabrasive cleaner and warm soapy water.
Wipe dry with a soft nonabrasive cloth.
•
Stainless steel surfaces: To maintain your
Tailgater’s high quality appearance, wash with
mild detergent and warm soapy water and wipe
dry with a soft cloth after each use.
•
Baked-on grease deposits may require the use
of an abrasive plastic cleaning pad. Use only in
direction of brushed finish to avoid damage. Do
not use abrasive pad on areas with graphics.
If a bristle brush is used to clean any of the Tail-
gater’s cooking surfaces, ensure no loose
bristles remain on cooking surfaces prior to cook-
ing.
Storing Your
BLACKSTONE Tailgater Combo
•
Store in dry location.
•
When an LP cylinder is connected to
BLACKSTONE Tailgater Combo, store
outdoors in a well-ventilated space and out of
reach of children.
•
Cover BLACKSTONE Tailgater Combo if stored
outdoors. Choose from a variety of
BLACKSTONE Tailgater Combo covers offered
by Blackstone.
•
Store BLACKSTONE Tailgater Combo indoors
ONLY if LP cylinder is turned off and
disconnected, removed from BLACKSTONE
Tailgater Combo and stored outdoors.
•
When removing BLACKSTONE Tailgater
Combo from storage, follow “Cleaning the
Burner Assembly” instructions before
starting griddle.
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace
parts of burner assembly or if you have trouble
igniting BLACKSTONE Tailgater Combo.
1.
Turn gas OFF at control knob and LP cylinder.
2.
Remove upper cover (Part 1 on parts list).
Содержание 1555
Страница 20: ...20 Step 10 Insert the flame temper to the grill box Step 11 Place grills into the grill grid ...
Страница 26: ...26 ...
Страница 52: ...52 ...