Black Max BM907500, Руководство оператора, Страница: 21 / 48

Page 17 — English
MAINTENANCE
DRAINING THE CARBURETOR

Turn the engine switch OFF .

Turn the fuel valve to the OFF position.

Position a suitable container under the carburetor drain
screw to catch fuel; loosen the screw.

Allow fuel to drain completely into container.

Retighten drain screw.
NOTE : Consult hazardous waste management guidelines in
your area for the proper way to dispose of used fuel.
TRANSPORTING

Turn the engine switch OFF . Disconnect any equipment
that is plugged into the generator.
 Verify the fuel valve is in the
OFF
position.

Allow 30 minutes of “cool down” time before transporting
the machine. Make sure engine and exhaust of unit are
cool.
 For security, insert the pins to secure the handle before
transporting.

Tilt the machine toward you until it balances on the wheels,
then roll the machine to the desired location.
 If transporting in a vehicle, drain the fuel tank, close fuel
valve and securely restrain the generator.

Provide a plastic sheet or absorbent pad below the
generator to catch any drips of fuel or lubricant.
REPLACING FUEL FILTER
See Figure 23.
Occasionally the fuel filter may become clogged and need
to be replaced. To purchase a replacement fuel filter contact
customer service or a qualified service center.
NOTE:
Fuel tank must be empty before replacing fuel filter.
Run unit until tank is empty, if needed, or inspect filter prior
to fill-up.
To replace:

Turn the fuel valve to the
OFF
position.


Remove the fuel line from both sides of the filter by
squeezing the ends of the retaining clip with pliers.


Slide the fuel line off.


Replace with new fuel filter.


Reinstall fuel lines to new fuel filter.


Pull on lines to make sure they are secured

Turn the fuel valve to the
ON
position.
CHANGING ENGINE BATTERY CHARGE
CIRCUIT FUSE
See Figure 24.
NOTICE:
Do not use a higher rated fuse other than the specified
amperage. This could cause damage to the product.

Grip both sides of the plastic fuse holder and twist apart
to reveal the fuse and spring.
 Insert new fuse and refasten the fuse holder by pushing
the two sides of the connector together and twisting to
secure.
NOTE: If spring came out of fuse holder when it was
opened, it should also be replaced inside the fuse holder
before securing.
BATTERY REMOVAL AND PREPARATION
FOR RECYCLING
To preserve natural resources, please recycle
or dispose of batteries properly.
This product uses lead acid batteries. Local,
state or federal laws may prohibit disposal of
batteries in ordinary trash.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
WARNING:
Upon removal, cover the battery’s terminals with heavy-duty
adhesive tape. Do not attempt to destroy or disassemble
battery or remove any of its components. Lead acid batteries
must be recycled or disposed of properly. Also, never touch
both terminals with metal objects and/or body parts as
short circuit may result. Keep away from children. Failure
to comply with these warnings could result in fire and/or
serious injury.
BATTERY CHARGER FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.