25
TRAVEL AIR-
Item code:BH06-A.
Instruction Manual
1
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
1
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape to
hold the foam in place.
1
3. Position the battery pack and receiver
behind the fuel tank. Use sing to two tie wraps
to hold the battery and receiver securely in
place as picture below.
Do not permanently secure the receiver and
battery until after balancing the model.
1
4. Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
1.Locate the aluminium wing dihedral brace.
*** Test fit the aluminium tube dihedral brace
into each wing haft. The brace should slide in
easily. If not, use 220 grit sand around the
edges and ends of the brace until it fits prop-
erly.
INSTALLING THE RECEIVER AND BATTERY.
Tie wrap.
Battery.
Receiver.
WING ATTACHMENT.
Aluminium tube 19mm
392 mm
1
2. Attach the aluminium tube into the
fuselage.
Right side.
