TRAVEL AIR.
Instruction Manual
16
Control horn of Rudder.
Drill 6mm diameter a hole of the mounting
rudder control horn on to the rudder .
Mark point.
Pen.
3mm x 40mm.
M3 lock nut
.
Nilon
control clasp.
and re-align. Double check all of your meas-
urements once more before the epoxy cures.
Remove any excess epoxy using a paper
towel and rubbing alcohol and hold the stabi-
lizer in place with T-pins or masking tape. Al-
low the epoxy to fully cure before proceeding.
RUDDER CONTROL HORN
INSTALLATION.
Rudder control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Epoxy glue.
Epoxy glue.
C/A glue
6) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the verti-
cal stabilizer mounting area. Apply epoxy to
the lower rudder hinge. Set the stabilizer in
place
