TRAVEL AIR.
INSTRUCTION MANUAL
11
1. Install the rubber grommets and brass
collets into the elevator servo. Test fit the servo
into the servo tray.
2. Mount the servo to the tray using the
mounting screws provided with your radio
system.
3. Mark the shape of the vertical on the left
and right sides onto the horizontal stabilizer
using a felt-tip pen
4. Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a modeling
knife.
When cutting through the covering to
remove it, cut with only enough pressure
to only cut through the covering it’s self.
Cutting into the balsa structure may
weaken it. This could lead to possible
failure during flight
Center line.
Elevator servo.
ELEVATOR INSTALLATION.
SERVO INSTALLATION.
Remove covering.
HORIZONTAL STABILIZER
INSTALLATION.
1. Using a modeling knife, cut away the
covering from the fuselage for the stabilizer
and remove it.
2 . Draw a center line onto the horizontal
stabilizer. Then slide the horizontal into the
fuselage.
