TRAVEL AIR.
INSTRUCTION MANUAL
15
3. Mark the shape of the vertical on the left
and right side on the rudder using a felt-tip
pen.
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rud-
der. Just as you did with the horizontal stabi-
lizer, make sure you only press hard enough
to cut the film, not the balsa rudder.
5. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 de-
gree to the horizontal stabilizer.
VERTICAL INSTALLATION.
Control clasp.
Hinge.
2. Slide the rudder into the fuselage as
same as picture below.
Remove
covering.
Hinge slot.
1) Using a modeling knife, remove the
covering from the top of the fuselage and the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage This
slot accepts the lower vertical.
Pen.
Remove covering.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
