PITTS
Item code: BH85-A
Instruction Manual
4
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
2)
Using a modeling knife, remove the
covering from over the pre-cut servo arm exit hole on
the aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
2. INSTALLING THE AILERON SERVOS
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Temporary pin to
keep hinge centered.
1. INSTALLING THE AILERONS
I. AILERON
Test fit the ailerons to the wing with the hinges. If the
hinges don’t remain centered, stick a pin through the
middle of the hinge to hold it in position.
Servo tray
Remove the covering
REPLACEMENT SMALL PARTS
Aileron
Aileron
Bottom side
.
Bottom side
.
1. Plastic - engine mount.
2. Wheels.
3. Wheel pants (left & right).
4. Aluminium landing gear.
5. Wing strut.
7. Tail gear set.
8. Fuel Tank
9. Spinner.
2x10mm
3x12mm
8
3 x 15mm
7
9
1
4x30mm
4x20mm
5x45mm
4
3
4x70mm
4x30mm
2
2
3x10mm
3x25mm
5
5a
5b
5c
