PITTS
Item code: BH85-A
Instruction Manual
11
Repeat the procedure to install the elevator pushrod
on the opposite elevator.
ELEVATOR SERVO INSTALLATION
1)
Install the rubber grommets and brass
collets into the elevator servo. Test fit the servo into
the servo tray.
2)
Mount the servo to the tray using the
mounting screws provided with your radio system.
Bottom side
M2 Lock nut
M2
Elevator pushrod
Bottom side.
Elevator pushrod
Bend 90 degree
Top side
C/A glue.
Bottom side.
C/A glue.
Elevator servo
Secure.
Cut.
Flaslink
Pushrod wire
servo arm
Secure.
Snap keeper
Using pliers, carefully make a 90 degree bend down at
the mark made. Cut off the excess wire, leaving about
6mm beyond the blend.
Insert the 90 degree bend down through the hole in the
servo arm. Install one nylon snap keeper over the wire
to secure it to the arm. Install the servo arm retaining
screw.
Elevator pushrod
M2 Lock nut
M2
