5
P- 36A HAWK-Item code BH41-A.
INSTRUCTION MANUAL.
1
2) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
1
3) Drill 1,6mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo.
o
4. Instal servo tray with aileron servo into
the wing as same as picture below.
Repeat the procedure for the other wing
half
.
2.INSTALLING THE AILERON CONTROL HORN
.
Thread.
Electric wire
Secure
Bottom side
Temporary pin to
keep hinge centered.
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Cut the covering
away from the slot.
Install aileron control horn as same as
picture below.
3 x 20 mm.