P- 36A HAWK-Item code BH41-A.
INSTRUCTION MANUAL.
2
This instruction manual is designed to help you build a great flying aeroplane. Please read this
manual thoroughly before starting assembly of your
P- 36A HAWK
. Use the parts listing below to
identify all parts.
WARNING.
Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is
capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU
ASSUME ALL RISK & RESPONSIBILITY.
If you are inexperienced with basic R/C flight we strongly recommend you contact your R/C
supplier and join your local R/C Model Flying Club. R/C Model Flying Clubs offer a variety of training
procedures designed to help the new pilot on his way to successful R/C flight. They will also be able
to advise on any insurance and safety regulations that may apply.
TOOLS & SUPPLIES NEEDED.
4
Thick cyanoacrylate glue.
4
30 minute epoxy.
4
5 minute epoxy.
4
Hand or electric drill.
4
Assorted drill bits.
4
Modelling knife.
4
Straight edge ruler.
4
2mm ball driver.
4
Phillips head screwdriver.
4
220 grit sandpaper.
4
90° square or builder’s triangle.
4
Wire cutters.
4
Masking tape & T-pins.
4
Thread-lock.
4
Paper towels.
Some more parts.
HARDWARE PACK
COWLING.
Landing gear.....
To avoid scratching your new airplane, do
not unwrap the pieces until they are needed
for assembly. Cover your workbench with an
old towel or brown paper, both to protect the
aircraft and to protect the table. Keep a couple
of jars or bowls handy to hold the small parts
after you open the bag.
Please trial fit all the parts. Make sure you
have the correct parts and that they fit and are
aligned properly before gluing! This will assure
proper assembly.
P- 36A HAWK
ARF is hand
made from natural materials, every plane is
unique and minor adjustments may have to
be made. However, you should find the fit
superior and assembly simple.
The painted and plastic parts used in this kit
are fuel proof. However, they are not tolerant
of many harsh chemicals including the
following: paint thinner, C/A glue accelerator,
C/A glue debonder and acetone. Do not let
these chemicals come in contact with the
colors on the covering and the plastic parts.
PARTS LISTING.
FUSELAGE ASSEMBLY
4
(1) Fuselage.
WING ASSEMBLY
4
(1) Right wing half with pre-installed
aileron.
4
(1) Left wing half with pre-installed
aileron.
4
Some more parts........
Tail section assembly
4
(1) Vertical stabilizer with pre-
installed rudder.
4
(1) Horizontal stabilizer with pre-
installed elevator halves.
SUGGESTION.
NOTE.