3
NOORDUYN NORSEMAN Item code: BH157
.
Instruction Manual
B1
C
B2
E
K
D
F
M
L
A
N
N: Decal sheet.
K: Cowling.
necessary. If the air or the iron is too hot, the film may
melt and holes may be formed.
This model is highly pre-fabricated and can be built in
a very short time. However, the work which you have to
carry out is important and must be done carefully. The
model will only be strong and fly well if you complete
your tasks competently - so please work slowly and
accurately.
When self-tapping screws have to be screwed into
wood, apply a little white glue to prevent them
shaking loose: just squirt white glue into the hole
and fit the screw.
Caution:
This model is not a toy!
If you are a beginner to this type of powered model,
please ask an experienced model flyer for help and
support. If you attempt to operate the model without
knowing what you are doing you could easily injure
yourself or somebody else. Please keep your safety
and well-being in mind at all times.
Important:
Before you start construction
Even if you have built a large number of RC models
please read right through these instructions and check
all the kit components against the parts list. We have
taken great trouble to keep construction as simple as
possible, without making any compromises in the area
of safety.
Note regarding the film covering
Minor creases or bubbles may develop in the film
covering due to major fluctuations in weather conditions
(temperature, humidity etc.); in rare cases you may
even find a slight warp in a component. These minor
faults are in the nature of film-covered built-up wooden
structures, and can easily be corrected using a heat
gun, as commonly used for modelling.
Creases:
Blow warm air over the area and rub
down with a soft cloth.
Wing wrap:
Hold the panel twisted gently in
the opposite direction to the wrap,and
apply warm air to remove the creases
from the covering.
Caution!
do not heat the film more than is absolutely
REPLACEMENT LARgE PARTS
+ This is not a toy.
+ Be sure that no other flyers are using your radio
frequency.
+ Do not smoke near fuel.
+ Store fuel in a cool, dry place, away from children
and pets.
+ Wear safety glasses.
+The glow plug clip must be securely attached to the
glow plug.
+ Do not flip the propeller with your fingers.
+ Keep loose clothing and wires away from the
propeller.
+ Do not start the engine if people are near. Do not
stand in line with the side of the propeller.
+ Make engine adjustments from behind the propeller
only. Do not reach around the spinning propeller.
SAFETY PRECAUTION
A: Fuselage.
B: Wing panel (B1, B2).
C: Horizontal stabilizer.
D: Rudder.
E: Aluminium wing dihedral brace.
F: Cockpit fuselage.
L: Canopy
M: Pilot