15
NOORDUYN NORSEMAN Item code: BH157
.
Instruction Manual
A/B Epoxy glue.
Pilot
Position the canopy so the rear frame on the canopy is
aligned with the rear edge of the cockpit opening. Use
canopy glue to secure the canopy to the canopy hatch.
Use low-tack tape to hold the canopy in position until
the glue fully cures. Wrap the tape completely around
the canopy hatch, as the tape does not stick well to
the covering. We used balsa sticks to hold the lower
edges of the canopy tightly against the canopy hatch.
Close
and Open
Locate the aluminium wing dihedral brace.
XIV. WINg ATTACHMENT
*** Test fit the aluminium tube dihedral brace into each
wing haft. The brace should slide in easily. If not, use
220 grit sand around the edges and ends of the brace
until it fits properly.
Attach the aluminium tube into the fuselage.
450mm
Aluminium tube.
19mm.
Insert the wing panel as pictures below.
Push in
Push in
Push in
Installing the fuselage hatch as same as picture below.