MDM-1FOX Item code: BH152
.
Instruction Manual
11
X. MOUNTING THE TAIL WHEEL
BRACKET
X. PLASTIC PARTS FOR WHEEL
Set the tail wheel assembly in place on the plywood
plate. The tail wheel bracket should be centered on
the plywood plate.
Secure
Drill a hole
2.5mm
3x10mm
Secure
3x10mm
Bettery
motor
Bettery receiver
Receiver
UBEC
ESC
XII. INSTALLING THE RECEIVER
AND BATTERY
1)
Plug the servo leads and the switch lead into
the receiver. You may want to plug an aileron extension
into the receiver to make plugging in the aileron servo
lead easier when you are installing the wing. Plug the
battery pack lead into the switch.
2)
Wrap the receiver and battery pack in the protec-
tive foam to protect them from vibration. Use a rubber
band or masking tape to hold the foam in place.
3)
Position the battery pack and receiver is as
picture below.
Do not permanently secure the receiver and battery
until after balancing the model.
4)
Using a 2mm drill bit, drill a hole through the side
of the fuselage, near the receiver, for the antenna to exit.
Collar
Secure