MDM-1FOX Item code: BH152
.
Instruction Manual
12
Position the canopy so the rear frame on the canopy is
aligned with the rear edge of the cockpit opening. Use
canopy glue to secure the canopy to the canopy hatch.
Use low-tack tape to hold the canopy in position until
the glue fully cures. Wrap the tape completely around
the canopy hatch, as the tape does not stick well to
the covering. We used balsa sticks to hold the lower
edges of the canopy tightly against the canopy hatch.
A/B Epoxy glue
XIV. INSTALLING COCKPIT
FUSELAGE
Use glue to secure the canopy to the fuselage. The
shape of the canopy, so make sure to install it in the
correct direction.
Pillot
A/B Epoxy glue.
Push in
Push in
Push in
Push in
XIII. WING ATTACHMENT
1,453 mm
1,197 mm
Aluminium tube wing dihedral brace.
32mm.
25mm.
*** Test fit the aluminium tube dihedral brace into each
wing haft. The brace should slide in easily. If not, use
220 grit sand around the edges and ends of the brace
until it fits properly.
Locate the aluminium wing dihedral brace.
Attach the aluminium tube into the fuselage.
6 x 75mm
Secure
