HOME RUN.
INSTRUCTION MANUAL
17
3) Position the battery pack and receiver
behind the fuel tank. Use the two light plywood
pieces, placed over the battery and receiver
and glue to the fuselage sides to hold the
battery and receiver securely in place. Use
15mm triangle pieces glued between the
fuselage sides and the plywood pieces to
reinforce the joints.
1) Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2) Wrap the receiver and battery pack in
the protective foam to protect them from
vibration. Use a rubber band or masking tape
to hold the foam in place.
3)
Using the hardware provided, mount
the main landing gear to the fuselage.
1) Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
2) Secure the switch in place using the
two machine screws provided with the radio
system.
See picture wing attach to fuselage.
Installing the canopy hatch as same as picture
below.
Switch.
Wing bolt.
Installing the belly pan as same as picture below.
Do not permanently secure the receiver and
battery until after balancing the model.
4) Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
INSTALLING THE SWITCH
WING ATTACHMENT
INSTALLING THE RECEIVER AND BATTERY
