HOME RUN.
INSTRUCTION MANUAL
15
1) Set the tail wheel assembly in place on
the plywood plate. The pivot point of the tail
wheel wire should be even with the rudder
hinge line and the tail wheel bracket should
be centered on the plywood plate.
2) Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
1) Install one adjustable metal connector
through the third hole out from the center of
one servo arm, enlarge the hole in the servo
arm using a 2mm drill bit to accommodate
the servo connector. Remove the excess
material from the arm.
After installing the adjustable metal
connector apply a small drop of thin C/A to
the bottom nut. This will prevent the connector
from loosening during flight.
Servo arm.
Coloa.
MOUNTING THE TAIL WHEEL BRACKET
INSTALLING THE THROTTLE PUSHROD
Throttle servo.
Snap keeper.
